Hi
I have the following set up:
Power Meter: Rotor Power Dual Left/Right
Turbo: TACX Bushido Smart
The question I want to ask is this, does the software take the power reading from my power meter and then adjust the turbo trainer resistance in Ergo mode.
I have been searching for a software like this for a long time.
On the bottom bar, the S/C is red as I don't have a speed or cadence sensor attached. The cadence comes directly from the crank arm PM. Speed I always use the GPS on my Edge520. I could add one to the Hub but don't see the advantage in Ergo mode. Maybe once I start looking to train with videos.
I only installed he software yesterday and have done one 5min test.
Thanks
Set Up
Re: Set Up
In Ergo mode It only does this thing for Lynx trainer (purely technical reasons, no politics involved). This might change in a future but for now you're out of luck unfortunately.Mrcrank wrote:...The question I want to ask is this, does the software take the power reading from my power meter and then adjust the turbo trainer resistance in Ergo mode...
VeloReality Forum Administrator