Set Up

[Mrcrank]

Hi

I have the following set up:

Power Meter: Rotor Power Dual Left/Right
Turbo: TACX Bushido Smart

The question I want to ask is this, does the software take the power reading from my power meter and then adjust the turbo trainer resistance in Ergo mode.

I have been searching for a software like this for a long time.

On the bottom bar, the S/C is red as I don't have a speed or cadence sensor attached. The cadence comes directly from the crank arm PM. Speed I always use the GPS on my Edge520. I could add one to the Hub but don't see the advantage in Ergo mode. Maybe once I start looking to train with videos.

I only installed he software yesterday and have done one 5min test.

Thanks

[admin]

...The question I want to ask is this, does the software take the power reading from my power meter and then adjust the turbo trainer resistance in Ergo mode...

In Ergo mode It only does this thing for Lynx trainer (purely technical reasons, no politics involved). This might change in a future but for now you're out of luck unfortunately.

[Mrcrank]

cool. thanks for the reply